Want this question answered?
Remove the breather cap at rear of tractor, on the left side of the PTO it pulls straight out. It has a dipstick on it. You should be able to add fluid there as well.
under the seat were do you add the hydraulic fluid
in the back axle
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
The hydraulic reservoir on the case 730 should be in about the same area as the case 630......on the right side of the tractor at the rear of the engine and on what would be the bell housing is a large cap screw type plug. There should be a dipstick not too far from it....you add hydraulic oil there, if it is a case-o-matic. If it is a standard transmission, then the dipstick and the plug should be on the rear of the tractor around where the seat bolts on.
In the half valve kanooter barring. Unless it is a four barring year 2000-2011, you can put it through the top of the piston.
You don't. A Ford 7108 is a loader, not a tractor. Find out the model number of your tractor and repost if you still need an answer.
Either Power steering fluid or in certain cases 10 weight engine oil
Looking at the rear of the tractor you will see two bolts above the center link bar on the rear axle. These are the filler plugs for your hydraulic and rear axle. Look under the driver side of your seat, there is a dipstick to check the hydraulic, differential, and wet-brake fluid levels.
In the front part of the hood, there should be a metal flapper that you can lift up. There will be a cap below it, that is where you add hydraulic fluid.
Hydraulic fluid should be poured in the oil tank.
Rear of the tractor,to the right of the bracket for the top link, there is a hex-head bolt with the dipstick attached to it.