Want this question answered?
Hydraulic fluid should be poured in the oil tank.
Barber chairs are often raised and lowered using gas or hydraulic struts. These struts work by using strong springs or pressurized gas. Some of these devices can be recharged, or have replaceable seals, but others are disposable items that are replaced as a unit.
You can add hydraulic fluid to Porsche convertible top motor by popping open your engine hood and then pouring the hydraulic fluid into the appropriate compartment.
under the seat were do you add the hydraulic fluid
To add hydraulic oil to an old Belmont barber chair, locate the nut on the base of the chair down by the foot area. Remove the nut and add the oil by using a small funnel. A Belmont barber chair must not be laid on its side for transporting because the oil will leak out.
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
in the back axle
Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.
Should be next to the brake fluid cup. DJ FLIP Housepartykings.com
The Ford Jubilee has three areas for fluid. The transmission has a filler cap near the gear shift. The hydraulic fluid has a filler cap under the edge of the seat and the differential has a filler cap behind the seat. There is a small dipstick on the right hand side to determine hydraulic fluid level.
Use hydraulic jack oil, available pretty much anywhere - I used Johnson's, 1qt bottles are $7.99 at my local O'Reilly. To fill, or replace, the fluid you'll first remove the seat cushion. It should just lift off. Under that there will be a hole in the center of the base, it may or may not be covered by a plastic cap or a screw on older models. Remove the cap to access the fluid reservoir. I would suggest removing as much existing fluid as you can before adding more, to avoid overfilling the pump. You can find a suction gun at harbor freight for about $15 which you can use to remove as much of the fluid in the chair as possible, without having to disassemble the pump mechanism. Place your control lever in the full down position, this will allow clear access to feed in the suction tube, as well as assure the chair is fully "down" and thus the reservoir as full as possible. Once empty, refill with hydraulic jack oil. Add one quart to start, and pump the chair up. If it gurgles while raising and before topping out, or when lowering, lower and add another 2-4oz and repeat the process until it makes no liquid noises when being raised, and doesn't gurgle or gush when being lowered. If you add too much fluid, the seals may be damaged and/or the chair will be very difficult to lower after being raised. Also do not EVER use any oil/fluid which mentions "stop leak".
thru the dipstick and vent hole by your bucket levers