answersLogoWhite

0


Best Answer

in the top of the Power Steering reservoir on the passenger side of the engine.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you add power steering fluid in a 2002 Monte Carlo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the power steering fluid located in a Monte Carlo?

It is serviced in the power steering reservior.jd


How do you add power steering fluid to a 1986 Monte Carlo?

Remove cap to power steering reservoir, add fluid, place cap on reservoir when done.


Where is the power steering location in the 2003 ss Monte Carlo?

where do i put the fluid Its under alternator.


Where does power steeing fluid go in a 2004 Monte Carlo?

On the 2004 Monte Carlo you may want to check with the dealer but I believe that this car was equipped with electronic steering assist and does not have a belt driven pump


Where can you find the power steering diagram for a 2006 Monte Carlo?

The library.


What kind of power steering fluid is recommended for a 2003 Monte Carlo?

it dose not mater most pro shops when they run out of it the will use tranz fluid it is almost the same thing


How do you add power steering fluid to a 2000 Monte Carlo?

The Power Steering unit is located under the alt. Make sure the engine is cold. Very tight area. I connected a rubber hose to the bottom of my funnel.


Where is power steering fluid reservoir for a 2000 Chevrolet Monte Carlo ss with the v6 3.8 engine?

The power steering reservoir is located on the passenger side rear of the Engine compartment underneath and behind the alternator. . It is a very tight fit.


Where is the power steering fluid cap in a 1998 Monte Carlo z34 3.8 liter?

It should be on the driver Sid eof the ngine compartment towards the front about a foot down.


Where is the camshaft sensor on a 1998 Monte Carlo?

right behind and below the power steering pump on the block.


Where is the power steering pump on a 98 Chevy Monte Carlo?

on the front of the engine and it is run by the serpentine belt.


Where is the camshaft position sensor on 2001 Monte Carlo 3400 v6?

its located behind the power steering pump...you would have to remove the power steering pump to access it