Hydraulic fluid ?? P/Steering, Plug in top of pump on side of motor at front of motor Hyd/Remotes, Gear box dip stick and fill behind seat, large cast plug ??
under the seat of tractor is the hydraulic reservoir. fill it to the line on the dipstick.
A Bobcat loader that will not lift or tilt probably is low on hydraulic fluid. Check the hydraulic fluid and fill to the recommended level.
Remove the fill plug and top it off with hydraulic oil.
The only hydraulic fluid which is typically in a road tractor is the power steering fluid, and you simply fill that to the fill line on the reservoir. If it's been fitted with a PTO, that's an aftermarket system, and that, as well as the hydraulic tank, depends on who the aftermarket supplier is.
all of the components for the top, including a plug in the side of the motor to fill with fluid from are under the back seat area. Refill for fluid is dex trans fluid.
It can be, DOT3 or 4 is the fill for most hydraulic clutch systems.
Check hydraulic fluid level Fill with pistons in retracted position
On the slightly newer CK20S, if you are sitting in the tractor seat, the hydraulic fluid fill will be near your right hand as you reach down below the seat. It has a red cap on it that says "oil". This is NOT the engine oil, but rather the hydraulic oil.
There is a small round window on the transmission that can be seen just behind the clutch pedal on the left side of the tractor. The hydraulic fluid must be filled so the oil level is between the two lines etched on the window. It takes about 8 gallons of hydraulic fluid for a drain and fill. The fill hole is under the rubber plug on the raised portion of the seat area between the driver's knees. There are four drain plugs.
It should have fluid check/fill plugs on each cover.It should have fluid check/fill plugs on each cover.
Fill it at the same place you check the fluid level.
To top up the hydraulic fluid in a VW MK 1 Golf, you need to locate the hydraulic fluid reservoir attached to the brake master cylinder. Unplug the electrical fluid sensor and Fill the reservoir to the ÒMaxÓ mark.