0
To check the check engine light codes on a 1988 Acura Legend, you need to locate the diagnostic connector under the dashboard near the driver's side. Use a jumper wire to connect the two terminals marked "TEN" and "GRD." Turn the ignition key to the "ON" position without starting the engine, and the check engine light will blink to indicate the trouble codes. Count the blinks to decipher the specific codes, which can then be referenced in a service manual for troubleshooting.
What else can I help you with?
How do you check for diagnostic codes in a 1989 Acura Legend?
To check for diagnostic codes in a 1989 Acura Legend, first, locate the diagnostic connector, usually found under the dashboard near the driver's side. Use a jumper wire to connect terminals A and B of the connector. Turn the ignition to the "ON" position without starting the engine, and watch for the check engine light, which will begin to blink in a specific sequence to indicate any stored diagnostic codes. Count the blinks to interpret the codes according to the vehicle's service manual.
Is there a way to retrieve DTC's from a 1991 Acura Legend without using a scanner?
How do i pull codes for a 1989 acura legend
Reset the engine check light on Acura MDX?
Have vehicle scanned to determine problem and have codes cleared
Why would check engine light dim on 1993 acura legend?
The check engine light on a 1993 Acura Legend may dim due to a weak electrical connection, a failing bulb, or a fluctuation in the vehicle’s electrical system, such as a weak battery or alternator issue. It may also indicate that the engine control module is not receiving consistent signals. Any irregularities in the vehicle's performance or diagnostics should be addressed promptly to avoid potential engine problems. Consider having the vehicle scanned for trouble codes to identify the underlying issue.
How do you reset the check engine light on acura 3.2 tl 2005?
Have vehicle scanned to determine the problem and/or have codes cleared
How do you check engine light for a 94 Acura Integra?
To check a engine light you need some kind of scan tool and it will show you what kind of code or codes is set for the engine light to go off.
What causes Check engine light 2001 acura?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
How do you reset check engine light on 2000 Acura RL?
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
Where is the plug to check the engine codes on a 1997 Acura CL?
Behind the 'ashtray'? or spare change holder - lower left section at the base of the center console.
97 Acura CL d4 check engine?
If your 1997 Acura CL's check engine light is on, it could be due to various issues, such as a loose gas cap, faulty oxygen sensor, or problems with the engine's performance. It's best to use an OBD-II scanner to retrieve the trouble codes, which will help pinpoint the exact issue. Once you have the codes, you can address the specific problem or consult a mechanic for further diagnosis and repair. Regular maintenance can also help prevent future check engine light occurrences.
What if your 1994 acura just started shaking when stopped or slowing down and your check engine light just came on today what do you do?
First step is to have it checked for trouble codes. If the check engine light is on, the pcm has detected a fault and set a code.
Where is the plug to get the codes for a check engine light for 2000 acura integra?
The plug is under the dash on the passenger side. It should be a green plug just under the carpet..
