Buick LeSabre

Where do you connect the negative cable when jump starting a 2002 buick lesabre custom?


Top Answer
User Avatar
Wiki User
2009-06-08 02:03:15
2009-06-08 02:03:15

Ground on the engine block.

User Avatar

Related Questions

the torque for a 1988 lesabre custom is 110 ft. lbs.

Where do you find starter relay for 99 buick lesabre custom

Instructions for replacing radiator on 2000 Buick Lesabre custom

You have to pop the rear seat out and there it will be.

how much would it cost to replace the heater coil on a 1999 buick leSabre

With Buick, The "Limited" is always the more expensive upgrade version.

Yes you can. The only difference between the Custom and the Limited is the trim level (Seat fabric, wood grain, etc.) Everything else is interchangeable.

The PCV valve for a 2001 Buick LeSabre is located in the top of one of the valve covers. It is a plug in unit and is easily changed.

The 1998 Buick LeSabre custom sedan has a curb weight of 3,443 pounds. It has a wheel base of 110.8 inches and a ground clearance of 5.5 inches.

The Original Equipment Tire Was 205/75-14

pull the blinker lever towards you. and they will click off

the oil pump is on the passanger side, inside the timing chain cover. It is a job to get to.

fuel pump relay for you car, is located in the engine compartment fue box

Hold reset button for about 5 seconds then it should reset.

the crankshaft sensor is located behind the harmonic balancer on the ft timing cover

The battery is located under the rear seat cushion on your 2001 Buick Lesabre.

When looking into owning a gas mileage is an important factor. The gas mileage for a 1983 Buick Lesabre is 17 miles per gallon city and 24 miles per gallon highway.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.