You dont and even after they are hooked back up the code would have most likely been erased after the battery was disconnected.
Battery has been disconnected with in the last 50 starts.Battery has been disconnected with in the last 50 starts.
Remove the cables from the 2001 Monte Carlo, then take out the battery hold down. Lift the battery out and put the new one in. Install the hold down, then connect the cables back.
Replacing a battery in a 2001 Chevrolet Tahoe is very easy to do. You will just need to take off the battery cables off the battery and put them to the side. Remove the old battery and replace with the new one. Put the cables back on the correct posts.
check battery cables at battery may be lose.
If vehicle starts - probably a bad ignition switch If vehicle doesn't start could be a dead or low battery, loose or corroded battery cables
it is located under the airfilter. Remove the air box and the 2 screws holding the cables on the ECM. After the cables are disconnected you can just lift out the ECM.
The charging warning light should automatically reset if the battery is disconnected. Check the battery cables and ensure they are properly connected. Also check the alternator connections. If the light is still on there may be a problem with the new alternator.
The throttle position sensor is located on the throttle body. If you follow the throttle cables to the throttle body the TPS will be on the oposite side of the throttle body as the cables attach to.
No, I juet tried it on our 2001 S40 and it did not work.
Best and easiest way to change battery in any Volkswagen. Remember if your computer loses power it will go into limp mode and you will find yourself at the dealership for vag-com. Have a friend with a good battery and a set up jumper cables and hook cables from his battery to yours, loosen battery terminals on your battery and carefully remove battery with out knocking the cables off (remember keep power to the battery cables on your WW). Carefully install your new battery and tighten the terminals. With jumper cables still hooked to your car start your engine, then remove the jumper cables. I would then take car for a short drive to ensure that there is a full charge to the battery you just installed.
Corroded battery cables, loose battery wires at the starter, water in fuel tank, clogged fuel filter
remove the brace over the battery (left side). unbolt the box that houses the relays and fuses. undo battery cables and replace