just run it back to the fuse box and put it on the ignition fuse
the red one
The memory wire is blue on the Kenwood VZ907. Now I hope you can help me. I am trying to hook this same product in my vehicle. However, I cannot get past BUS-E50. What does this mean? The memory wire is blue on the Kenwood VZ907. Now I hope you can help me. I am trying to hook this same product in my vehicle. However, I cannot get past BUS-E50. What does this mean?
Yes
to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch
you have to get a memory card and hook it in the computer
No. Hook up the power wire first, then the ground wire. The ground wire is what acutually draws the power to the unit. As you will notice the power wont turn on if just the power wire is plugged in..
Hook up the red wire to the fuse box or another wire that gives power when the key is on. Hook up the white wire to a wire coming out of the headlight switch. This will make is so that when you turn your headlights on, the light will come on on the tach. If you don't mind the light on the tach being on all the time then just hook it to another power wire. Hook the black wire to a ground like a screw or a bolt. The green wire is the signal wire. Run it through your fire wall. Hook it up to the negative side of the coil. There will be a negative sign on the coil denoting the correct side.
the purple wire
what color is the memory wire on a 1997 ford explore
Cut off the eye of the hook with some wire cutters and then pull the hook through.
you hook it up to the white wire that comes out of your O2 sensor
power for amp IT GIVE YOU A POWER SOURCE WICH IS SUPPOSED TO BE HOOKED UP TO THE ACC (ACCESSORY) WIRE FROM YOUR CAR WHICH WILL GO ON AND OFF WITH THE IGNITION. THIS IS NOT A CONSTANT POWER SOURCE, DO NOT HOOK YOUR STATION MEMORY OR CLOCK TO THIS POWER SOURCE