answersLogoWhite

0

the little six pin blue connecter under the left side of the dash

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Were is the hook up connection for a scanner tool on a dodge charger?

Need to know what year Charger you have.


Where is the starter on a 2002 Dodge Intrepid with 2.7L engine?

underneath the car. somewhere near where the engine and transmission hook up.


Where do you hook the code reader on a 1995 Dodge intrepid?

under the driver side of the dash, it is a square 6 pin connecter


How do you reset the engine light on 2001 dodge intrepid?

Disconnect the negative battery cable for 10 minutes then re hook.


What to check for when engine light comes on my 2000 dodge 1500?

You hook up a scanner and check it for codes.


How do you jump start a Dodge Intrepid?

1993-1997 you hook the cables to the battery. 1998-2004 you hook the cable to the jump start posts under the hood, passenger side.


Can you put in a 1998 Dodge Intrepid 2.7l engine into a 2000 or 2002 Dodge Intrepid?

Yes you can but, you have to use the flywheel off of the 2002 engine on the 1998 engine other than that you just have to hook up the wiring harness off the 2002 onto the 98.


How do replace a temperature sensor on a Dodge Intrepid?

just unplug the wires going to it unscrew it. then insert new one then hook wires back up.


Where do you hook up the scanner for a 1994 Plymouth sundance?

To hook up the scanner for a 1994 Plymouth Sundance, locate the OBD-I diagnostic port, which is typically found under the dashboard on the driver's side, near the steering column. You may need to remove a cover or panel to access it. Once located, connect the scanner's cable to the diagnostic port, and then turn on the ignition to begin the diagnostic process.


Can I Charge battery in 2000 Dodge Intrepid while it is in the car?

Yes. Just hook the red cable to the red post, black to black and turn the charger on.


Where do you hook up my scanner to THE ECM IN a 2005 Dodge Magnum?

The OBD2 diagnostic port is under the dash on the driver side.


How do i jump start my 1998 Dodge Intrepid?

You hook the red and black jumper cables to the red and black jump start posts under the hood on the passenger side.