answersLogoWhite

0

Where do you insert tranny fluid on my 92 Volvo 960?

Updated: 8/20/2019
User Avatar

Wiki User

11y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where do you insert tranny fluid on my 92 Volvo 960?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you unlock my 1996 960 Volvo stereo?

i need the code to unlock the radio on my Volvo 960 1996


What is the lug nut torque for a 1993 Volvo 960?

The lug nut torque for that 1993 Volvo 960 is 63 ft.lbs.


How much does it cost to repair or replace a rod on 1996 Volvo 960?

how much will it cost to replace or repair rod for 1996 volvo 960?


What does a explanation point light mean on your 97 Volvo 960?

Brake circuit failure. Normally this means the brake fluid level is too low.


Will a transmission from a 1996 Volvo 960 work in a 1997 Volvo S-90?

Yes, the transmissions are compatible. The S90 was the re-branding of the 960 until 1998 or 1999.


How do you install timing belt 92 Volvo 960?

I would like to install a timing belt on my 93 960 volvo / how do I line up the cams with the crank shaft???


How do you reset the service light on a 1995 Volvo 960?

remove the rubber plug on the instrument panel (front of speedometer)Insert a small pin and hold for a few seconds, all done


What is the firing order for a 1996 Volvo 960?

firing order is 1342 for a Volvo 960 (1996) 1342 is the firing order for a 4 cylinder which would be a 940- as for the 960, the order is 153624 where 1 is closest to the front of the car and 6 to the cabin. (for 2.9 liter motors in '96 960)


What direction does the engine turn on a 92 Volvo 960?

Round and Round


How big is the gas tank on a 1994 Volvo 960?

20.3 gallons


How do you start a Volvo 960?

You put the key in the ignition and turn it clockwise


What is wrong if your Volvo 960's sunroof is not working?

If your Volvo 960's sun roof is not working, you might have an issue with the roof motor or with the fuse. You could also have a problem with the control switch or the wiring.