Check Owner's Manual.
If you do not have one.
Check Related links below.
You may have to pull seat off vehicle to be able to see what the problem is. It maybe broken wires if so you may have to solder it back in place.
How to Backflush Cooling Systems Check related link below.
To put a driver's side window back on track on a Ford Expedition you will have to reseat the window. Do this by removing the door panel and putting the window back in place. You can use silicone or Gorilla glue to attach the window. Leave the window in the up position for at least one day once you have it back on place.
back of assembly and twist.
Lift the car on a car jack, remove the tire off the car, remove the brake shoe/caliper and remove the old brake pad. Next put in the new brake pads, put the brake shoe/caliper in its place, put the tire back on the car and slowly lower the car to the ground.
Which engine??? If it's the 5.4 it is on the number 3 cylinder. Which is the third one back on the driver side of the engine.
Lewis and Clark got back from there expedition on February 22nd
I had the same problem on my 2001 expedition and took it back to the dealer and there is an ampilifer mounted in the side wall near the subwoofer and it was bad, not how to get to it, hope this help.
Inside bumper back of it
i have a 2000 expedition and all you have to do is open the back hatch door, then fold the seat down, and finally grab the bar in the middle of the seat and push forward and pull up and it wlli be unlocked to pull right out..
the plugs on the back are very difficult. How is this done.
The light assy has to be removed and the bulbs removed from the back.