0
Where do you place the jack on 1994 Toyota Camry with a rear flat tire?
Wiki User
∙ 14y ago
Underneath each door there are two notches on what looks like the siding, but is actually part of the frame of the car. Assuming you have a scissor jack, you would place it right where the notches are. There are four spots total with notches.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you flat tow a Toyota Camry?
Call your nearest tow company.
How do you remove rear speaker covers and speakers 2002 Toyota Camry SE?
use a flat screw driver.
How do you get a 97 Camry's dome light cover off?
There are no screws in the dome light cover of a 1997 Toyota Camry. You can pry the cover off with a flat bladed screw driver.
Map light replace bulb in 1996 Toyota Camry?
To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.
Toyota Camry wagon 1995 How do you change the dome light in the car no screws are apparent?
Pry the lens off with a small flat screwdriver
How do you get the spark plug wires off the distributor in a 1994 Toyota Camry LE 4-cylinder?
each wire has a plastic cap on the distributor end with a small tab on the end cap. With a small flat tip screwdriver, lift the tab a little and the cap should pull off easy.
How do you remove the cover and replace the overhead dome light on a 1994 Toyota Camry?
There is a small slot on the hard plastic cover near the end of the dome light you will need a small flat head screw driver insert the screw driver in that slot use a back and forth motion to remove it.
How long does it take to remove and replace a tranie on a 1990 Toyota Camry automatic transmission?
im a Toyota tech. in a fully equipt garage it should take about 3-4 hours. you will probably be charged about 8 hours flat rate
Can a Toyota tacoma be flat towed?
Can a Toyota tacoma be flat towed? Well it depends on how flat it it if you are talking so flat that it could be a ramp then no but maybe not that flat I am sure you could!!!!
How do you take off cap from the axle nut on 2002 Toyota Camry driver side front?
Generally speaking a flat screw driver can be used to pry it out a bit or to work it loose to you can just wiggle it off. Sometimes it is so sealed in place due to age and corrosion that it cannot be removed without damage.
Toyota Previa fuse box?
Toyota Previa fuse box is located underneath center console. It has a latch mechanism holding it in place at front of console but can be pried up with flat edge screw driver.
How do I replace the battery in a 97 Toyota Camry remote control device?
On the end of the fob is a small slot to insert a small flat screwdriver and it will snap open. Pay attention to the polarity of the batteries for re-installment, and the fob will click back together.
