answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where do you put powersteering fluid at in a Oldsmobile delta 88?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the name of the hose from where you put powersteering fluid in that goes directly into the powersteering pump for a 2003 ford explorer xlt 4.0?

The powersteering reservoir has the filler tube molded on/in it.


Where do you put the power steering fluid in a 1997 Oldsmobile Delta Eighty-Eight?

There's a cap on the top of the power steering unit, remove it and put it in there, it might even have a little dip stick.


How much powersteering fluid do you put in to your engine?

Fill the power steering reservoir until the dipstick in it reads full.


What freon do you put in a 82 Oldsmobile delta 88?

A 1982 Oldsmobile was built to use R12, it would need retrofitted to R134a..


How do you put transmission fluid in a 2000 Oldsmobile?

Put trans. fluid in through the dipstick hole, be careful not to overfill


Where is the powersteering pump on a 2004 Buick rendezvous?

The Power steering pump is located underneath where you put the power steering fluid.


Where do you put the transmission fluid in a 1997 Oldsmobile Cutlass?

You add fluid at the same place you check it.


Can you use brake fluid for power steering?

NO NO NO!!!! OMG I hope you did not try that already. Break fluid and powersteering fluid have different properties for different pressures, they are not the same thing and if you put break fluid in your power steering system you will destroy your car.


How do you put transmission fluid in a 1995 Oldsmobile Aurora?

You put it down the tube that holds the trans dipstick.


Can you fit 24 inch rims on a 1988 Oldsmobile 98 regency?

How can I put 24s on 1981 delta 98


How do you put transmission fluid in a 1998 Olds Delta 88?

Down same tube that holds trans dipstick.


How do you replace the belt tensioner on your 1989 Oldsmobile delta 88?

Move the tensioner to release belt (use bolt in center of pulley and move with socket) Then simply remove bolts from block. Reverse to put on new one.