Want this question answered?
Not necessarily. In a simple circuit V=IR, so if the resistance in a circuit remains constant, then voltage and current are directly proportional, so an increase in one will increase the other. If you were to change resistance and keep voltage constant, then the current would be inversely proportional to resistance, so as resistance went up, current would go down.
For to keep the resonant frequancy constant L*C has to stay same. Lets say if you double L you have to divide C by 2 to keep the same resonant frequency. If only L increases Resonant frequency decrease, this is same for C.
The cut in voltage is that voltage where after the current increase rapidly and it's value is different-2 for different type of semiconductor. for silicon it is 0.7 and for germanium it is 0.3 volt. It means if you made a diode from silicon than applied voltage below 0.7 volt will not able to flow current (if flow than it is in term of few micro ampere) . it means diode will stay in off mode and for germanium same things will happen and it will rest on off condition below 0.3 volt(applied).
Economies of scale (costs decrease), diseconomies of scale (costs increase), constant returns to scale (costs stay the same)
An inertial reference frame is a frame ... a box, a laboratory, a space capsule etc. ... in which Netwon's laws of motion hold true. Example: My office on the earth is not an inertial reference frame. An object in motion doesn't "remain in constant uniform motion without application of an external force", because of air resistance. Also, an object released in the middle of the air doesn't stay there, it accelerates toward the floor.
A: Actually no. If the current can be limited it may Even oscillate and each diode will behave differently even tough they are from the same family. A reverse breakdown usually means a blown diode in a circuit the hear from a hi voltage and the hi current will surpass its power dissipation and blow short most of the time.
It means they stay still, or they move at constant velocity.It means they stay still, or they move at constant velocity.It means they stay still, or they move at constant velocity.It means they stay still, or they move at constant velocity.
Both a stuck reverse switch and shorted wiring can be causes for reverse lights to stay on. Under normal circumstances, the reverse lights turn off as soon as the vehicle is shifted out of reverse.
Not necessarily. In a simple circuit V=IR, so if the resistance in a circuit remains constant, then voltage and current are directly proportional, so an increase in one will increase the other. If you were to change resistance and keep voltage constant, then the current would be inversely proportional to resistance, so as resistance went up, current would go down.
Either the reverse switch is defective or out of adjustment.
non-constant speed is when the speed for an object does not stay the same
non-constant speed is when the speed for an object does not stay the same
parallel
its not, if ur accelerating ur not staying at a constant speed.
A: A zener diode is manufacture to reverse breakdown at a certain voltage this voltage will remain almost constant no matter how much more voltage is available [within operating parameters]. this zener must be able to sustain both itself operating currents plus the load
The parts of an experiment that stay the same.
yes