Onto the exhaust port of the engine...
bolt it on the motor
you take a bolt and bolt it.
yes, you need to find a bolt that is quite long and stick it through the holes on the scooter so that about 5 inches of it is sticking out on the side you want the peg to be on, slide skateboard bearings on the bolt and screw a bolt on the end, there you go, a scooter peg.
no
undo the bolt der but i want to take off my break on my scooter but i dont no if i want to. B:
i got the same prob
its a m10 1.50.
you may burn up the exhaust valve.i would not do it.
Your scooter will start oozing out poop. So i suggest shooting the poop with a uzi to prevent oozing. Hope this helps :)
No. Removing a restricter on a scooter's carb will make it faster but decrease mpg. If you are talking about a restrictor on the exhaust, then most likely you will increase mpg, but boy is it LOUD.
An improved flow of air and fuel mix will make the scooter faster. You can do this with an aftermarket exhaust.
Exhaust manifold torque is 25 lb/ft with anti-seize lube.