Want this question answered?
The intelligence signal is in the AM envelope.In AM modulation, the carrier is amplitude modulated by the signal. This signal appears as the envelope of the carrier. You can demodulate it by following the peaks on each cycle of the carrier. You can either follow the positive peaks or the negative peaks - it does not matter if the original modulation is symmetrical.
the pwm output can be converter to ppm by passing pwm through a monostable multivibrator with a low stable state and high quasi stable state and which is negative edge triggered.
Obviously by feedback
Pulse-Amplitude Modulation
Your question is quite incomplete. If you want to convert a PwM (pulse width modulated) infrared signal, just pass on the width info to a fixed carrier wave (amplitude modulate it), and the job is done. At the other end, demodulate using standard If stage as in any superheterodyne radio reciever.
PWM is Pulse Width Modulation. It is a Digital control is used to create a square wave, a signal switched between on and off.
There are many forms of digital signals PWM, PAM, and more Basically is a signal that carry information to be extracted to its original form.
PWM stands for Pulse Width Modulation. It is a technique used in electronics to encode information in a pulsing signal. In PWM, the duration of a pulse in a waveform is varied to convey information. This method is commonly used to control the power delivered to electrical devices, such as motors, LEDs, and other components, by adjusting the average power over time.
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT
PAM-pulse Amplitude Modulation It encodes information in the amplitude of a sequence of signal pulses. PPM-Pulse Position modulation PWM-Pulse Width Modulation.It results in variation of average waveform.
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT
COMINT, ELINT, and FISINT