The light is built into the bumper on that car. Just above the plate.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light
yes there is, just above rear plate.
Same circuit/fuse as the parking/tail lights.
It is directly above the plate. It is held in by two phillips screws.
In N.Y. State you do. I would imagine that it would be the same in all states as the license plate light makes the license plate readible at night.
Yes, it is illegal for the light above the rear license plate to be out in Missouri. This light is necessary for the license plate to be visible at night, which is required by law for safety reasons. Driving without this light working could result in a citation.
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle
this light is called the license plate light
The license plate light circuit is protected with the tail light circuit fuse.
The 2001 Toyota Camry license plate light fuse can be found in the fuse box. The license plate fuse will be labeled as the tail light fuse.
A Chevy Tahoe's license plate bulb can be used to light up the license plate. In the dark the license's plate will still be visible.