gidday under the consul then look under the the carpet there is a slot in the carpet be very careful if you unplug it before you disconnect the battery it WILL deploy wait 30mins before you attempt any work on srs systems.
you will need a rovacom or similar to reset it
There is a problem with the SRS. Seek out professional help. Not a DIY repair. I have a P38 Range Rover and when the drivers seat is moved the SRS switch (the yellow one)which is located under the seat is sometimes knocked which shows as a fault. If you just turn the car off and check the connection the fault is fixed
to reset you have to press the button that says doodlebops
iT WILL RESET WHEN THE PROBLEM IS REPAIRED.
SRS light indicates airbag fault, if this is showing then you should get your car checked.
Suplimental Restraint System The air bags.
If the SRS or Supplementary Restraint System light stays on in your Rover 25, it is possible that the connector for the air bag that crosses under the driver's seat is disconnected. There are clips that hold the wire together and if disconnected, it is possible the airbag will not activate in an accident.
it means there is a fault with your airbag system,
if the engine is running and the red srs light is on. it indicates that the airbag/bags are not working correctly. if the light is on then goes out when the ignition is on. they are functioning correctly
Will have to go onto a Land Rover computer, or aftermarket version. The fault will most likely be a seat belt pre tensioner needing replacement.
The ECU has detected a problem with the SRS. It is dangerous to work on this system therefore have this repaired by a professional.
srs stands for supplimentary restraint system, which is your airbag system. If the light is on all the time this would indicate a fault in the system and would have to be checked by a garage or somebody with diagnostic equipment to determine what the fault is
the srs system needs to go through a self check then the codes will be able to be cleared.this will only be reset if the relevant parts have been replaced .there are many reasons why the lamp may be on,all the codes and details will be retained in the srs ecu for ever.this information will be used in the event of an accident .There fore it is not in anyones intrest to try and switch the srs light out unless the faults have been repaired in a professional manner