The sensor is located at the front of the engine near the oil filter housing. To the left of the housing. 2.5 Z3
The 1996 BMW 328 camshaft position sensor is located on the front of the cylinder head. The camshaft position sensor should be labeled as such.
http://forums.bimmerforums.com/forum/showthread.php?t=886595
Near bottom of trans bell housing right side
All depending on the year of your vehicle will determine the location of the camshaft position. The camshaft position sensor, or cps, is located just under the head gasket. They are two different sensors, so be sure to deal with the correct one.
small sensor on front of cylinder head. connected under manifold,must remove manifold.
X5 does not equipped with V6 engine. It's I-6...
Remove oil filter cap. Using your torcT30 bit and Allen 5ml loosen back shaft to expose sensor. Remove and replace sensor , reverse install camshaft.
Exhaust camshaft sensor signal and the intake camshaft sensor signal. Happened to my BMW few days ago.
Located next to the crankshaft pulley
Mine went into transmission failsafe mode, and takes off very very slow
The 2001 BMW 325 crankshaft position sensor can be found on the back of the engine. The position sensor will be near the bottom of the rear engine cover.
I mean a Trans position sensor I mean a Trans position sensor