0
The bolt to drain the coolant is on the water pump. The water pump is on the left side of the bike, just in front of the oil filter. Just remove the 10mm bolt CLOSEST TO THE OIL FILTER. You'll want to remove the radiator cap prior to doing this so the coolant drains freely. NOTE: Make sure the coolant is cold so you don't get scalded.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the oil capacity for a 1987 Honda Shadow VT1100C?
Engine oil capacity for the 1986 Honda VT1100c Shadow is approximately 2.2 quarts of engine oil Engine oil capacityfor the Honda VT1100c is approxmately 2.2 quarts
What is the engine oil capacity for a 1986 Honda VT1100c Shadow?
The 1986 Honda 1100 cc engine oil capacity is three pints. The manufacturer recommends that you never overfill the engine oil.
Does a 1986 Honda Accord Dx gas tank have a drain plug?
NO.
What is shifting sequence FOR a HONDA VT1100C motorcycle?
1 down 3 up if newer than 1986 85 and 86 1 down and 4 up with neutral between 1st and 2nd on all models
How do you drain the radiator coolant on an 1986 Corvette?
there should be a pitcock on bottom of radiator to drain it. or take the bottom radiator hose with motor cold of course .
Where do you drain the engine oil for 1986 Honda 350 fourtrax 4x4?
into a form of containment unit
Is there a drain plug in the rear end of a 1986 Honda TRX 250?
yes there is it is a big nut on the rear of the rear end
1986 Honda Accord Overheating?
Check thermostat make sure fans work replace coolant easily done check manual
Where is the cooling fan switch located on a 1986 Honda CRX?
If you are talking about the coolant temperature switch that turns the fan on when the coolant reaches the right temperature, then mine it is located in the bottom of the radiator directly under the fan.
1.5 fit in a 1986 Honda CRX?
The 1986 Honda CRX already has a 1.5.
What was the cost of a new Honda Accord in 1986?
the cost of the Honda accord in 1986 is $34995
How do you know if the head gasket on a 1986 Honda CRX is blown?
look for coolant in the oil and do a compression test. two adjacent cylinders with low compression will indicate a blown headgasket.
