It is located between the distributor at the back or the engine.
on the intake manifold on the driverside.
It should be in the tail shaft of the transmission. That's where mine is on 94 auto transmission.
The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.
Where is the crank sensor located on a 94 ranger 4.0 motor
should be by balancer
If it is the same as a 1993 Ford Explorer it is in the interior fuse panel
The Mass Airflow sensor (MAF) is located between the air filter housing and the air intake duct. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.
On the engine.
The 1998 Ford Ranger speed sensor ring can be located on the passenger wheel. The speed sensor ring will be on the inside of the brake rotor.
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
in the tank
Look by the balancer.
The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.
It's on the front of the engine. Look for a large, exposed gear behind the crankshaft pulley. The sensor will be almost touching that gear.
There are 2 heated exhaust gas oxygen sensors , 1 screwed into the outlet on each exhaust manifold on a 1993 Ford Ranger 4.0 L .
It should be located in the oil pan. On my ranger its on the drivers side.
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
how to i change a clutch in a 1993 ford ranger
the o2 sensor is located on the exaust manifold
What model year? The earlier 2.3L did not have a MAP sensor.
Where is the ford ranger 2004 revcounter sensor conected
From Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups: All 2.5L engines, 3.0L and 4.0L 1993 thru 1999 and 2.3L engines 1993 through 1997 utilize an IAT sensor. Models following those years do not have an AIT sensor. If your vehicle is equipped with an AIT sensor, the sensor is located inside the air intake duct between the air cleaner housing and the throttle body.
It's located with the MAF