The 1998 Ford Ranger speed sensor ring can be located on the passenger wheel. The speed sensor ring will be on the inside of the brake rotor.
1998 and later models are not equipped with a Vehicle Speed Sensor (on the tranny). The PCM receives vehicle speed information from the antilock brake system rear wheel speed sensor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.
Exhaust manifold.
the vehicle speed sensor is on the tranny it hooks onto your speedometer. the engine speed sensor is on the front of the engine, two different sensors guys.
right in front if the battery terminal on the transmission
Where is the speed sensor on 1998 eagle talon 5 speed
The vehicle speed signal comes form the trans computer via the output speed sensor on the front of the trans.
I'm not a mechanic / technician but on a 1998 Ford Ranger 4.0 liter EFI , V6 engine : I believe the crankshaft position sensor is at the front of the engine When standing in front of the vehicle looking into the engine compartment it is just to the left of the crankshaft damper near the bottom of the engine
A 1998 Ram does not have an input speed sensor.
To locate and change the front speed sensor on a 1998 GMC Sonoma 4X4, first, lift the vehicle and secure it on jack stands for safety. The speed sensor is typically mounted on the front axle housing; trace the wiring harness from the differential to find it. Disconnect the electrical connector, remove the mounting bolt, and pull the sensor out. Install the new sensor by reversing these steps, ensuring the connector is securely attached.
A 1998 Jeep with a 5.2L does not have an input speed sensor.
It is on the front of the transmission, between the cooler hoses.
wHereis the abs wheel speed sensor located on 1998 Oldsmobile bravadaI