it doesn't
the OBD II plug should be under the steering wheel area at the bottom of the Dash.
OBD plug is located below the fuse box left side under the steering wheel. (2002 T2 model).
To reset the OBD (On-Board Diagnostics) system on a 2008 Subaru Outback, you can disconnect the negative battery terminal for about 15 minutes, which will clear the stored trouble codes and reset the system. Alternatively, you can use an OBD-II scanner to erase the codes directly. After resetting, reconnect the battery or turn the ignition back on, and check if the check engine light remains off. Remember that this will also reset other settings in the vehicle.
The Data Link Connector (DLC) is under the bottom part of the Instrument Panel, on the driver's side, by the door...
The 2002 Jeep Wrangler OBD 2 port is below instrument panel, left of brake pedal
The 2002 Toyota Tundra OBD 2 port is on lower edge of dash/ next to console; connector faces down
The 2002 Volkswagon Beetle OBD 2 port is under dash at left side
It is to the right of the steering wheel column under the dash.
The OBD-II plug for a 2002 Nissan Xterra is located under the dashboard on the driver's side. You can find it near the steering column, typically above the brake pedal. It may be covered by a plastic panel, which can be easily removed to access the connector.
The 2004 Subaru Legacy OBD 2 port is under dash at left, next to kick panel"
The OBD-II diagnostic connector for a 2005 Subaru Outback wagon is located beneath the dashboard on the driver's side. It is typically found near the steering column, mounted to the vehicle's frame or near the fuse box. To access it, you may need to remove a plastic cover or kneel down to see it clearly.