answersLogoWhite

0

On the lower half of motor closest to front of car right by the oil pan.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How much refrigerant does a 97 grand prix gt need?

90 LBS


Will a serpentine belt change on a 90 Pontiac grand prix require removing engine mounts?

Absoultly not.


Where is fuel pump on a 1994 Pontiac grand prix?

the fuel pump on 90% of any car is in the tank its self


Why is my 90 grand prix stop lights stuck on?

Check for mis-adjusted or defective stop light switch


Where is the starter located on a 90 Corvette conv?

I have a 90' ZR1 and the starter is under the plenum a costly job about $700 plus parts. They have to remove the top of the engine to get to it.


Will a 89 grand prix se2.8 transmission fit in a 90 grand prix se 3.1?

It should, but you might want to check with a local gm dealer service dept. Local junk yards may have interchange info too.


What Refrigerant is used in a 1999 grand prix?

most vehicles use r-134 from mid 90's and up


How many times did nigel mansel win the Monaco grand prix?

Nigel Mansell has never won the Monaco Grand Prix. Ayrton Senna holds the record for most race wins in this circuit. He has a total of 6 wins in the years 1987, 89, 90, 91, 92 and 1993.


Will the transmission from a '90 Chevy Celebrity wagon bolt up to a '92 Grand Prix with the same 3.1 engine?

Yes the transaxle should bolt up.


What kind of supercharger is on a 1999 Pontiac Grand Prix GTP?

A 1999 Grand Prix GTP uses an EATON M90 supercharger that displaces 90 cubic inches of air during every revolution. This results in a rating of 240 horsepower at the crank at 5200RPM, and a "pavement pounding" 280ft-lb of torque at 3600RPM!


Where is the coil pack in 1997 Grand Prix SE?

if it is a 4 cylinder it is undder the intake i am lie 90% sure if it is a v6 it in the front passenger side of the engine compartment


Where is and how do you remove the starter motor on your 90 golf gl?

Disconnect battery, starter is located somewhere by where engine meets transmission. Remove all electric connections then remove bolts securing starter. Install new starter, attach electric connections, connect battery and your done.