Next to the cam gears beneath the valve cover
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
It should take you less than a half an hour to replace the TPS sensor.
Try camshaft position sender or drivers door control
Its located at the right rear corner of the cylinder head.
If the door opens from the outside it may be the child safety latch. Open the door and there will be a lever on the rear of the door move this to the off position.
The HyundaiÊ1.3 liter engine crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
SENSOR IS ON TOP OF THE TRANSMISSION -JUST BELOW THE BACK OF THE BATTERY
The 199x and newer Crown Vics have a door position sensor not a Pin Switch. Hope this helps! Radioman
An automatic door has a controller, an electrical sensor and a motor. The sensor detects an approach to the door either by the interruption of a laser beam or by a pressure pad. This is set up to send a signal to the controller which triggers the motor on the door which moves the door to the open position. The motor then closes the door after a set time period unless the sensor is re-triggered in that time.
The door ajar sensor, on a 2005 Ford escape, is located inside the door panel behind the door lock. There is a sensor on each door.
The sensor that detects the position of the door may not be functioning properly once the door is closed.
On a 2 door Coupe, yes. ON a 4 door or a convertible the ckp is on the rear of the block.