0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is there a crank sensor on a 93 suburban?
NO. A crank sensor are cam sensor was not introduced until the year 1996.
Why does your 1996 Lincoln mark VIII have no spark?
ck cam shaft sensor, check crank shaft sensor also.
Where do you find the crank shaft position sensor on a 1996 Nissan altima?
Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..
Where is crank shaft sensor on 1996 chev?
Need to know what size engine it has.
Where is the crank shaft position sensor on a Grand Am 1996?
DOWN BY THE OIL FILTER EASY TO DO
Would the crank shaft sensor stop the 1996 Chrysler van from turning over?
No.
Is there any adjustment to a crank shaft position sensor on a 1996 ford ranger 2.3 liter?
no
On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
Where is the crank shaft sensor loacted on the engine for 1996 F-250 7.3 diesel?
The crank shaft sensor is located on front of block above the harmonic balance wheel (bottom pulley on front of engine). This is easiest to get at from underneath the vehicle.
Where is the crank shaft sensor located on a 1993 C-1500 pickup?
There is not 1 on that year. They were NOT used untill 1996
Where is the crank sensor located on a 1996 Concorde?
the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft.
Where is the crank shaft sensor located on a 1996 S10 truck with a 2.2L?
under the coil pack rr of engine block
