on front, left hand side, in behind the harmonic dampener, close to the exciter ring on the crankshaft
What position is the crank sensor on a f250 ford pickup
it will be on the lower front of the engine even with the crankshaft
the cam shaft sensor is down by the crank shaft pully and when you are facing the motor it is on the left side of it it has a siliver bracket and takes a 10 mm socket and a extension dont pull off the belt you can work around it THE OLD SENSORS THAT ARE UNDER RECALL IS BLACK WITH GOLD BRACKET
its under the water pump
I think the bolt is a 10mm then pull it out. Have not had many problems with the 6.0 cam sensor like the 7.3L
On top of your rear axle (pumpkin) just above the drive shaft yolk it has two wires sticking out of it.
Where is cylinder temp sensor on 2000 Ford f250 with v10 engine
The O2 sensor on a 1988 F250 is not near the engine. Go to the exhaust manifold and down the length. It is near the catalytic converter.
I have a 1997 ford f250 4x4, 5.4 gas engine. We just changed our crankshaft sensor. ours is located bottom front passenger side of engine behind the A/C pulley on the side wall.
Check your maf sensor, the computer may not realize the engine is running because it is sensing no air flow, aside from that and a malfunctioning cam or crank sensor it could be a hundred things, what you need is a bit more information about HOW its not running before you can find a definitive why.
Which oxygen sensor? There are two of them. They each have 4 wires and each wire has two colors. There were two models of the f250 also, need to know engine size. Sorry.
The fuel pump on a 1979 Ford F250 is located on the side of the engine. It uses a mechanical rod to operate the pump directly from the vehicle's cam shaft.