answersLogoWhite

0


Best Answer

It is usually engraved on either the top of the reflector or the side of the sprinkler head.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is a fire sprinkler head date located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much water does a wet pipe fire sprinkler spray per minute?

25-150 gallons per minute is standard depending on the type of sprinkler head. Residential sprinklers will be closer to 25. That flow is for a SINGLE sprinkler head. Typically the fire will be extinguished by just activating one sprinkler head.


Is this a recalled fire sprinkler head model 804A upright?

yes


How do you add zones to a fire sprinkler system?

Fire sprinkler systems are effectively already zoned - you don't need to do anything special. When your fire sprinkler system detects a fire, it doesn't set off all the sprinkler heads at once. Instead, each fire sprinkler head goes off when the temperature underneath it reaches a specific temperature, meaning only the ones affected by the fire will go off.


Where can I find specifications for Central sprinkler head 804A?

Call tech support for tyco fire. They absorbed central sprinkler co.


What are the two basic categories of fire sprinkler systems?

Residential and commercial Wet and dry standby Manual and automatic Deluge and sprinkler-head-valved


What is the difference between deluge and other fire sprinkler systems?

In a deluge system the water comes out of all sprinkler heads at once, compared with most fire sprinkler systems in which each sprinkler head has its own heat-sensitive trigger. There are major design differences in how much water you need for a deluge system and what safety interlocks are built into the system to prevent accidental water damage.


What is the maximum distance between fie sprinkler heads?

http://www.archtoolbox.com/materials-systems/fire-supression/83-sprinklerspacing.html http://www.igin.com/article-247-heads-up-on-sprinkler-head-spacing.html


Where to use upright sprinkler and pendent sprinkler?

: The difference between an upright head and a pendent head is, an upright sprinkler is designed to be installed upright in the branchline piping of a sprinkler system. The pendent is designed to be in the pendent or 6 o clock position, with the deflector facing downward. It is important that you always install sprinklers in accordance with their designed listing; you cannot install an upright sprinkler in the pendent position, for example. you can usually find this information with the data sheet supplied with the sprinkler. If in doubt, contact the sprinkler manufacturer. Sprinkler installation is regulated by National Fire Protection Association or NFPA for short, document number 13.. This standard gives the codes for proper location, selection, and installation of fire sprinklers.


What is the maximum distance between fire sprinkler heads?

That would depend upon what type of sprinkler it is, how far apart they are, what type of occupancy, what is the purpose of the wall and the material of the wall, among other things. For example, some walls do not need any sprinklers at all.


What is the effectiveness of fire sprinkler system in relation to its installation sprinkler head height?

How many length between two sprinkler2 in the room building. How many lenght between two sprinklers at the ceiling. 3 meters


How do fire sprinkler systems put out fires?

Fire sprinklers have two major components that operate in response to a fire: the fire sprinkler heads which are connected via a series of pipes to a fire pumps. Water pressure is kept in the head by a series of valves in the pump. and is kept in the heads by little vials of colored liquid. During a fire, the liquid inside the sprinkler heads heats up and starts to expand, eventually causing the vial to burst. Water that was kept in the pipes pours out of the sprinkler heads. The water pouring out of the sprinkler heads causes the pressure in the fire pump to drop. In response, the pump kicks on and pumps more water from the municipal water supply to keep the sprinkler flowing. NOTE: this is how "wet pipe" fire sprinklers, the most common types of fire sprinklers, work. Other sprinklers (dry pipe, deluge and pre-action) are slightly different.


Henry S Parmelee is credited with inventing the first commercially successful?

Open head sprinkler Closed Head Sprinkler (1874)