Best Answer

on a 99 model there are two of them and its located under the intake. quite a bit of work but not bad.

User Avatar

Wiki User

โˆ™ 2010-06-20 21:28:34
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is a knock sensor on a 01 Chevy silverado 4.8?
Write your answer...
Related questions

Where is knock sensor on 01 silverado?

Need to know the engine size. YOU will need to ASK your question again. THANK YOU.

Where is the knock sensor located on a 01 Chevy silverado z71 with a 5.3 engine size?

That engine has 2 of them and believe it or NOT. they are UNDERNEATH the intake manifold. You will have to remove the intake to even SEE them are to service them.

Where is the bank 2 sensor 1 on a 01 Chevy silverado 1500?

Bank 2 is the side of the engine where the #2 spark plug is. On my 99 Silverado it's on the passenger side.

Where is the bank one 01 sensor located on a 2005 Chevy Silverado 1500?

Bank 1 is the drivers side of the engine. #1 o2 sensor will be the first sensor that is in the exhaust pipe that's closest to the exhaust manifold on drivers side head.

Where is the bank two sensor 01 located on a 2005 Chevy Silverado 1500?

Bank 2 would be the passenger side of the engine, so the first O2 sensor threaded into the exhaust leading from bank 2 would be B2 S1.

Are the bolt patterns same on 97 vs 01 Chevy Silverado short bed?

Hhh not easy

How many quarts do a 01 1500 v8 5.3l Chevy silverado take?

6 qts. with new filter.

Why does my 01 Chevy silverado run out of gas at half tank?

the float in your tank is probably bad, causing inaccurate readings.

What temperature should a 01 Chevy silverado run at?

195 to 210 degrees is just fine. If any hotter then there is a problem.

What holds in crank sensor on 01 Chevy s10 4.3?

Should be one 10mm bolt.

If you have a 2001 Chevy Cavalier with an engine from a 2004 which O2 sensor should you buy 2001 or 2004?

that depends which wiring do you have the 01 or the 04 if 01 then get the 01 if not get the other

When was Knock Knock - album - created?

Knock Knock - album - was created on 1999-01-12.

What are the symptoms of a bad temperature sensor for 01 Chevy Malibu?

loss of control over the air and heat

What is the procedure to set timing on 2001 Chevy S-10 4.3L?

there is none. an 01 chevy with a 4.3 has a camshaft sensor and a crankshaft sensor that send critical info to the computer, it then adjusts timing electronically.

What type of transmission is in a automatic 01 Chevy Silverado?

1/2 tons have the 4L60E / 4L65E 3/4 tons used the 4L80E / 4L85E

When did Knock First end?

Knock First ended on 2004-10-01.

Where is the PCV valve located on a 2001 Chevy silverado with a 5.3 liter v-8?

I have an 01 Chevy 5.3 single cab short bed 4x4. The PCV valve is on the back of the left valve cover.

Where is the speed sensor wire for 01 Chevy Venture van?

passenger side transmission housing where the half shaft connects from the wheel

Do wheels 22 inch and tires 305 22 inch fit a 1999 Chevy silverado?

Yes they will. I have 305 24" wheels for my 01 Tahoe. They fit well.

Is it possible to have a 2001 Chevy Silverado 1500 to turn from a 2 wheel drive into a 4 wheel drive?

Anything is possible if you have the money, but it would be by far cheaper to just purchase a used 01 Silverado with 4 wheel drive and sell yours.

Where is it 01 2500 hd 6.0 knock sensor location?

There are 2 of them on that engine and both of them are UNDERNEITH the intake manifold. You can't see them are service them until you remove the intake manifold.

What oil does 01 Chevy Silverado use?

5W30 Weight in the cold months and 10W30 in the hot months. DON'T use anything heaver then the above are it will burn the valve train up.

What is the best sounding exhaust for a 01 z 71 Chevy silverado... going to get one but don't kno what kind any suggestions?

Flow master mufflers add power and sound awsome.

Will a 97 Chevy transfer case fit a 01 Chevy?

yes it will

Where is the AC high pressure switch. on an 01 Chevy Suburban?

the high pressure sensor is mounted on the back of the a/c compressor with a snap ring and sealed with an "o" ring.