Ford Ranger

Where is ac charge valve on 1993 Ford Ranger?

012

Top Answer
User Avatar
Wiki User
Answered
2014-08-28 00:36:13
2014-08-28 00:36:13

The 1993 Ford Ranger air conditioning charge valve can be found on the top of the air conditioning compressor. The charge valve will be marked as the low pressure valve.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?


The bleed valve is located on the drivers side of the bell housing.


On 3.0L and 4.0L engines, the PCV valve is mounted in the valve cover near the brake booster. - Haynes Repair Manual #36071 - 1993-2005 Ford Ranger Pickups.


how to i change a clutch in a 1993 ford ranger


Begin by removing the cover to your 1993 Ford Ranger valve cover. Remove the gasket and clean the surface. Put the new gasket on and return the elf cover to its original position.


egr valve location on a 1997 ford ranger 23l


200 ford ranger tappet valve clearance


There is a heater control valve on the 1999 Ford Ranger. There is no thermal vacuum valve on this year of the vehicle.


In the top of the valve cover , on the drivers side of the engine , near the rear of the valve cover , next to the firewall


The engines in a 1993 Ford Ranger are fuel injected , so there is no carburetor


no It has fuel injection and 4.0 engine


Yes, a 2003 Ford Ranger tailgate will fit a 1993 Ford Ranger. As of July 2013, the average price of a new tailgate for a Ford Ranger is around $160, plus tax and shipping.


I believe it's on the passenger side of the transmission behind a heat shield


The PCV valve, on your Ford Ranger 2.5 liter engine, is located on the outside of the air cleaner housing. The valve is on the back of the housing.


The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.


where is the PVC valve located on a 1990 ford ranger 2.3 L



I have a '93 Ford Explorer and it hold 19 gallons From the Chilton Ford Ranger guide: "1993 Ranger with standard wheelbase: 16.3 1993 Ranger with long wheelbase: 19.6"


Some cars have no valve and you have to loosten the line to bleed the cyl. Fill the slave cyl as full as you can get it before mounting it .


The label on the drivers side door is 225 70 r14 for a 1993 ford ranger.


the PCV is mounted in the valve cover near the brake booster


check egr system,make sure vacuum reaches egr valve when is supposed to


where is a throttle at in 1993 ford ranger xlt3.0 show me diagram


what are the specification of valve adjustment for 2000 ford ranger wl inlet


its in the valve cover by the brake booster



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.