the actuator door is above the actuator motor which is above the floor vent ducts in the middle of the dashboard at the bottom easy fix on F- 150 on a Expedition you have to remove the middle console first to even get to that section of the dashboard.
how to replace a blend door actuator on a 1999 ford ranger
In the back/middle
How do i replace blend door motor
You don't!
90% of the time it is the temp mode door actuator located in the driverside rear of the truck
I believe you are looking for blend door actuator???
It is possible the temperature blend door actuator has failed. Do you hear a thumping type noise when adjusting the temperature? If so, it is highly likely the actuator needs replacing. Very common
If it is broken. It could be a faulty temperature blend door actuator.
Assuming you are looking for the temp blend door actuator, remove the center console and you will see the actuator under the dash. It should be white in color.
Start with: Possible control, blend door or blend door actuator, low pressure switch, leak in system.
You have a faulty temperature blend door actuator located directly behind the radio. Remove the radio and remove the blend door actuator held to the heater case with three 8mm screws, and replace it.
the blend door actuator has a gear missing teeth an it can't finish the comand