The orifice tube is located in the line at the condenser discharge connection.
2002 ford taurus where is the orifice tube located
Bleed or Weep Holes are located at the elevational top or bottom of the Orifice Plate. The Weep Hole is tangent to a circle equal to 98% of the line I.D. DRAIN HOLES are located at the bottom of the Orifice Plate to prevent liquids in a gas or condensate in a steam flow from damming up behind the Orifice Plate. VENT HOLES are located at the top of the Orifice Plate to allow gases in a liquid flow to vent pass the Orifice Plate.
The orifice tube is located between the engine and the fire wall. The windshield wiper cowling has to be removed to gain access to the orifice tube.
There is no orifice tube on that car. It uses an expansion valve located in the evaporator case under the dash on the passenger side.
A 1987 Dakota uses an expansion valve, not an orifice tube.A 1987 Dakota uses an expansion valve, not an orifice tube.
It is located in the 3/8" aluminum line located at the bottom of the evaporator.
The orifice is located in the low side hard pipe at the condenser outlet. This is the hard pipe which goes from the condenser to the evaporator with the low side port.
BR
It doesn't have an orifice tube. It has an expansion valve that is located inside of the evaporator box. The evaporator assembly will have to be removed and taken apart to replace the expansion valve.
What orifice tube? An orifice tube is part of the AC system pull off the lines going into the accumulator. You'll see it. DoratheExplorer
This year does not use an orifice tube but a expansion valve instead. This is located under the hood on the passenger side where the Refrigerant lines go into the evaporator under cowl (dash area) looks like an aluminum block. If it did have an orifice tube it would be located in the same place only inside the high side refrigerant line, or the smaller of the two lines and can be unbolted and separated to get to the orifice tube.