its on the passenger side rear one.
Bank 1 is the drivers side of the engine. #1 o2 sensor will be the first sensor that is in the exhaust pipe that's closest to the exhaust manifold on drivers side head.
where is bank one sensor 1 located on 2001 maxima Bank 1 sensor 1 is located at the upper front left hand side of the motor. My 01 20th anniversary edition has 4 sensors. Just recently replaced all 4.
The ignition failure sensor in an 01 Stratus RT is located above the condenser. It is near the ignition coil. ?æ
Disconnect one of the 02 sensors and read the newly generated code. Then reconnect it and erase the code. Read codes again the new Bad 02 sensor code should disappear. Hence the code that followed your procedure will be for bank 1 or 2. You know which sensor you just disconnected and the new code has then identified what bank it resides in so then you will know which bank is which. You can bet real money on that.
where is the location of lelay for 01 nissan pathfinder moonroof
on the 01 zetec motor it is located below the alt. on the engine block.
Bank 2 is the side of the engine where the #2 spark plug is. On my 99 Silverado it's on the passenger side.
Bank one sensor one can be found on the drivers side before the cat. The best way to change the sensor on an '01 XL-7 is to buy an oxygen sensor tool, the socket model works best! These can be found at any auto parts store. I believe they are 22mm?
there is none.there is a pressure regulator however.and there is a tank sensor sometimes that measures pressure in the tank. but not on all vehicles.
'01 Infinity I30's have 4 O2 sensors. Two in Bank one and two in Bank two. They are located on the exhaust system. On the front of your engine you will see four harnesses, blue, red, white and black. All but the blue wire runs under the engine to the exhaust system. Bank 1 is the rear of the exhaust and Bank 2 is the front of the exhaust (by the manifold). Black and white go to Bank 1 and blue and white go to Bank 2. Go to infinitihelp/Ownership/common.com and there is a diagram of the exhaust system. Your most likely looking for the black harness/wire.
01 toyota salara oxygen sensor how to replace it code p1135 p1155
On my 01 sportage it is located on top of the air filter housing.