The blower resistor is UNDER the maxifuse center on the engine firewall. The maxifuse center needs to be removed with 2 bolts and the resistor is in the top of the blower heater assembly held in place with 4 screws. Difficult to get to but can be done.
On a '97 it's accessible under the hood, about top center of the firewall.
The blower motor resistor is generally located close to the blower motor.
Probably in the fuse box located underneath your hood.
the heater blower is located under the dash on the passenger side. easy to change ,4 skrews.
Remove cover on firewall under the hood, then remove the cabin filter and you will see the blower.
It is on the evaporator case and is held in with 2 screws.
The blower motor for this vehicle is located on the heater plenum approximately in the center of the firewall. It is located near the top of the engine compartment. The motor is covered by a plastic cowl that is secured by six bolts.
The battery is under the back seat.
Well since I put the question out there, Inow have the answer: It was the blower motor module that needed to be replaced. It was burned out. It cause me 251.00 for part and labor.
faulty switch
if your blower motor is not properly working it is most likely your blower motor resistor. it is located next to the blower motor which can be found by looking through your glove compartment. 17.99 at your local autozone
It is behinde the glove box on passenger side it takes a 5.5. mm socket to get it off... good luck.