0
passengers side behind harmonic balance pulley bottom of engine.Put on lift take off tire makes job easier
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will 92 park avenue start with bad cam sensor?
No it will not start need to change the cam sensor & crank sensor!
Where is cam sensor located on 91 Ford Tempo?
Cam sensor not used on '91 Tempo. Only introduced in '92 model year.
Where is cam shaft position sensor on 92 camaro?
It does not have one on that year.
Where is the thermostat on a 92 Oldsmobile 98 regency?
Follow the upper radiator hose to the engine - the thermostat is in the bulb housing that that hose attaches to.
Where is the crank angle sensor on a 92 eclipse?
the cam angle sensor is the crank angle sensor it preforms both jobs
Where can you find a repair manual for 92 Oldsmobile regency eliteelite?
Go to Advance Auto Parts and you'll find it. The price would be around $16:00.
Where is cam sensor on the 92 dodge spirit 2.5 lt?
It is in the distributor. It is the plate under the cap and rotor.
What does code 54 mean on a 92 Dodge Dakota?
code 54 means there is no signal from the pickup coil aka ( cam sensor ) to the pcm.
What is wrong when a 92 Oldsmobile sputter?
If the Oldsmobile is a 98 Regency, check the vacuum lines on the engine. When you open the hood, look to the lower right section of the engine. You will see thin black tubes (hoses) in this area. Make sure that they have not become disconnected. This applied to a 1990 Olds that I had trouble with. a bit.
Why On a 1992 buick park avenue it dies when engine gets hot around 30 miles i hope its other than the cam sensor is there a way to check if it really is the cam sensor without high cost?
Autozone tests sensors for free. Also, check the cam magnet and make sure it's not damaged. added.. CAM sensor is pretty easy to replace; it's just under the water pump pulley. I replaced that myself. CRankshaft sensor will also trigger code 17 and 18 (same as CAM sensor), which the book says is CAM sensor; there is no CRANK sensor code. I had that happen on my 92 PA ultra, and it would stall consistently on the same stretch of road after 45 minutes. Since replacing the CAM sensor didn't fix it, I had the garage replace the CRANK sensor after it died completely. Works fine now. Crank sensor is not as easy; they will have to remove the main drive pulley on the end of the crankshaft to get to it.
Will the engine cradle subframe from a 1990 Oldsmobile 98 regency fit a 1994 Oldsmobile delta88?
Lots of guys have upgraded to the newer engine , better tranny and bigger front brakes by using 92 and up complete cradle , suspension . If your getting free or already use it. Or you can upgrade by using 97 up .
Where is the throutle sensor on a 92 Pontiac transport?
throttle sensor for a 92 pontiac transport
