0
'87 M103 engine 300E. There is one sensor up front with a three pronged plug and there is one up back of the engine compartment under the oil filter. Just look for the head of the hex screw. Bit misleading because they are both referred to as crankshaft sensors or at least they were to me. Sorry I cannot give you more details but will clean this answer up a bit tomorrow with part nrs. etc.
-j
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor on a 1986 Mercedes 300e?
I was told it is on the top to the bell housing
where can i find a air flow sensor for a 1990 300e benz 3.0?
You can buy it online here: http://www.drivewire.com/vehicle/mercedes-300e/mass-air-flow-sensor/
Where is the oxygen sensor on a 1992 Mercedes 300E?
it will be located somewhere on the exausht pipe after the manifold approx
Where is the oil pressure sensor on a Mercedes-Benz 300e?
I saw on another forum that the oil pressure sensor is under the oil filter.
Your 1989 Mercedes 300E is hard to start in the AM but once it starts it will restart normally during the entire day The next AM the same hard start Possible crank shaft sensor issue?
hi! cold start valve.
Where you the blower motor resistor on Mercedes 300e?
The blower motor resistor on a Mercedes 300e is located beneath the blower motor on the Mercedes 300e, if ever it needs replacing.
How many fuel pump in Mercedes Benz 300e?
There are two fuel pumps in a Mercedes 300E
How do you replace glow plugs 300e Mercedes 1997?
how to change glow plugs on1997 mercedes 300e
Mercedes 300e cylinder head bolt torque specs?
what is the over all torque for a Mercedes 300e 1991
Can you use regular gas in a 1987 Mercedes Benz 300E?
Can u use regular unleaded gasoline in 1987 Mercedes Benz 300e
Mercedes 300e firing order?
ok
Where is the 1991 Mercedes 300e voltage regulator?
The voltage regulator for a 300e Mercedes is mounted on the rear of the alternator. The regulator is a replaceable item, independent from the alternator.
