The crank sensor is on the left side top of the bell housing behind a shield. One bolt to remove but be careful as the wires are extremely thin.
it is inside the distributor.
Check
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
in bthe sky
Bob
The cam sensor is the distributor, The crank sensor is in the front bottom left side of the timing cover. Behind the balancer.
try replacing crank sensor
yes but the cam sensor and the crank sensor work to geather so make sure to have it tested if you can to make sure wich is bad .
In the back by the coil pack.
Where is the knock sensor for a 99 pathfinder
1391 is for an intermittent loss of the cam sensor or crank sensor signal
One 10mm bolt holds the crank sensor to the top tranmission bell housing on the left side. From underneath bend the shield back that hides it and take the bolt out .. you can access the plug to disconnect the wiring easier.