0
Bob
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the crank position sensor on a 98 Chevy cavalier 2.2?
In the back by the coil pack.
Can a bad crank sensor cause a car to not run?
crank sensor can somtime make it not start, i just had to replace mine last week on a 98 2.2 cavalier that stoped all the bucking and cuting out . . now my cam sensor is gone and now the car wont start sooo .. . i say it lil bt mix of crank and cam sensor . i say replace both of them at the same time and save your troubles . . . that should be you problem. replace the starts first your spark plugs and cabbles and your gas filter then go to you coil pack and mogue .. if not dont make a differences then switch over your crank and cam sensor .. . hope that helps yeah out
Does a 98 cavalier have a map sensor?
yes
Where is the speed sensor on a 98 Chevy Cavalier?
in the axle
Crank sensor location on a 1989 Oldsmobile delta 98?
The crank sensor is located behind the Harmonic balancer. Try not to break the rubber within the Harmonic balancer when removing or on the safe side replace both the Crank sensor and the Harmonic balancer ( the big pulley on the bottom - most part of the engine.)
How do you replace crankshaft position sensor on a 1988 olds 98?
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
How do you change an o2 sensor on a 98 Chevy Cavalier?
don't have the foggiest
Where is the crank and camshaft sensor located on a 98 Chevrolet silverado?
The cam sensor is the distributor, The crank sensor is in the front bottom left side of the timing cover. Behind the balancer.
Why will your 98 intrepid turn over but not fire?
try replacing crank sensor
98 ford contour does crank sensor control spark and fuel?
yes but the cam sensor and the crank sensor work to geather so make sure to have it tested if you can to make sure wich is bad .
Where is crank sensor on 98 pathfinder?
The crank sensor is on the left side top of the bell housing behind a shield. One bolt to remove but be careful as the wires are extremely thin.
Engine code PO335 98 Chevrolet Cavalier?
Crankshaft position sensor circuit malfunction.
