0
It is the far driver side of the front head.
It is the far driver side of the front head.
Wiki User
∙ 9y ago
Wiki User
∙ 9y agoIt is the far driver side of the front head.
Add your answer:
Earn +20 pts
Where is the camshaft sensor on a 1996 Chrysler sebring?
On a 4 cylinder it is on the end of the cylinder head. On a 6 cylinder it is part of the distributor.
How many thermostats on a 2007 Chrysler sebring?
The 4 cylinder has two. The 6 cylinder has 1.The 4 cylinder has two. The 6 cylinder has 1.
How do you change an EGI valve in a 1997 6 cylinder Chrysler Sebring?
EGI.. do you mean EGR?
What is the recommended oil for a 2003 Chrysler sebring limited 6 cylinder 24 valve DOHC?
5w30
Where is the ignition coil located in a 2000 Chrysler sebring?
4 cylinder, it is on the top of the valve cover. 6 cylinder, it is inside the distributor and is not serviceable.
Oil pressure light in 2002 Chrysler Sebring 6-cylinder?
The 2002 Chrysler Sebring six-cylinder engine oil pressure light alerts the automobile operator when the oil pressure is too low. The oil pressure light will illuminate red.
Where is cylinder 5 on a 1999 Chrysler Sebring?
It is the driver side cylinder on the rear cylinder head.
Where can you find the choke heat sensor on a 2003 Chrysler sebring 4-cylinder coupe?
A 2003 Chrysler Sebring is fuel injected and does not have a choke.
What is the towing capacity for 2006 chrysler sebring 6cyl?
The towing capacity of a 2006 Chrysler Sebring 6 cylinder is 1,000 pounds. This light capacity allows the car to tow very small trailers for short distances.
Where is the camshaft located on a 2005 Chrysler Sebring?
The camshaft is in the cylinder head.
Where is the oil filter on a 1998 Chrysler Sebring 2.5 6 cylinder?
It is on the radiator side of the engine, just above the oil pan.
How do you set the timing on 1996 Chrysler Sebring 2.5L 6 cylinder?
If you are asking about ignition timing there is no adjustment it is controlled by the engine controller
