answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-12-04 20:51:10

where is the radiator drain plug on a Mercury Villager

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


There is a drain plug in the transmission pan.


Open the drain plug on the passenger side of the radiator.



On the oil pan. -> -> -> On the bottom.


The oil drain plug is located on the lower right side of the oil pan. You can easily get to the oil drain plug and oil filter by removing the right front wheel.


The radiator drain plug is at the passenger side rear of the radiator at the very bottom corner. There are two drain plugs in the block, they are very difficult to get at, and usually not necessary.


what is the spark plugs firing order for a mercury villager 1997


You mean the oil drain? In the oil pan.


where is the drain oil plug on a 2010 9.9 mercury outboard motor


According to one of Ford's websites : The spark plug gap for a 1993 Mercury Villager , 3.0 V6 is : ( .032 inch )


1995 Mercury Truck Villager Van 3.0L EFI SOHC 6cylThe Spark Plug Gap.032 (In thousandths of an inch)


Look on the bottom or rear of the radiator or just remove the lower radiator hose


The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.


According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993 Mercury Villager with the 3.0 liter V6


I was looking at the 1998 Mercury Villager Owner Guide ( and one of the Ford websites ) and they both show the spark plug gap as ( .034 inch )


Both the Owner Guide and fordparts.com show ( .034 inch ) spark plug gap for a 1998 Mercury Villager 3.0 liter V6 engine


When facing the front of the Mercury Mountaineer, the drain plug is on the lower left of the radiator. Place a bucket under the drain plug spigot before loosening to catch the coolant. To empty the radiator, turn the drain plug three-quarters of a turn. Tighten the drain plug before re-filling with coolant.


There are drain plugs on each side of the block. They are difficult to reach unless you have the car on a lift.


There is no such thing on this vehicle.


Not from the factory , only if someone has added a drain plug in the transmission pan


For the 3.3 litre V6 engine in a 1999 Mercury Villager : One of the Ford websites shows ( .044 inch spark plug gap ) The 1999 Mercury Villager Owner Guide shows ( .039 to .043 inch spark plug gap ) * check the Vehicle Emissions Control Information ( VECI ) decal in the front of your engine compartment


For the 3.3 litre V6 engine in a 2000 Mercury Villager : One of Fords websites shows ( .044 inch spark plug gap ) The 2000 Mercury Villager Owner Guide shows ( .039 to .043 inch spark plug gap ) * Check your Vehicle Emissions Control Information ( VECI ) decal in the front of your engine compartment


Screwed into the engine. Follow the spark plug wires.



Almost directly under the steering column.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.