Fuel filter is mounted just in front of the passenger rear tire on the frame. bleed off fuel pressure before disconnecting and have safety glass rags and a catch pan when changing it.
A ( 1996 ) Ford Aspire has a 38 liter / 10 U.S. gallon fuel tank .
The 1996 Ford Thunderbird Owner Guide shows the ( Motorcraft FL-400A ) engine oil filter for the 3.8 liter V6 fordparts.com shows the ( Motorcraft FL-400-S ) engine oil filter for the 3.8 liter V6
38
There is no Wix (or any other aftermarket) cross reference for this fuel filter. However, Toro uses this same filter on some of their equipment. If you order Toro part number 100-3192, it will arrive in a Briggs and Stratton box with part number 820311 on it, and you can buy it for $38-$40 instead of $65+ that everyone wants for it if you order it under the Briggs number.
you get a 38 rench then get a 4 9 rench
One liter equals 1000 milliliter. Accordingly 38000 ml = 38000/1000 liters. Result is 38 liters.
I bought my TMX 155 in the Philippines and it has had five tankfuls of fuel in it. I get 42 km/ liter when mostly going in fourth gear. When mostly driving in towns using lower gears I get 34 or so.
38 grams per serving
I need to know
3.8 quarts are about 3.60 liters.1 liter ~ 1.05669 US quarts1 US quart ~ 0.946353 liters
The Fuel Filter Canister on a 2.2L 1996 Honda Accord is in the back of the engine compartment near the drivers side by the fire wall. It is a round canister with one hose attached to the top, and the bottom, it also has a band around the center of the filter attaching it to a bracket. It is to the left of and slightly below the brake master cylinder. The Best way to relieve the fuel press is by removing the main 20 Amp Fuse in the Fuse Box under the hood and starting the car and letting it die until all the fuel in the line is used up. After reinstalling the Filter, reinstall the Fuse and turn the ignition switch on and off a few times all the way to the start position without starting the car, this lets the fuel pump repressurize the system.Fuel FilterReplacementA WARNINGDo not smoke while working on fuel system.Keep open flame away from your work area.• While replacing the fuel filter, be careful to keep a safedistance between battery terminals and any tools.The fuel filter should be replaced whenever the fuel pressuredrops below the specified value [265 - 314 kPa,2.7 - 3.2 kgf/cm2, 38 - 46 psi with the fuel pressure regulatorvacuum hose disconnected and pinched] after makingsure that the fuel pump and the fuel pressure regulatorare OK.1. Place a shop towel under and around the fuel filter.2. Relieve fuel pressure (see page 11-112).3. Remove the engine wire harness bracket and powersteering feed hose clamp.4. Remove the banjo bolt and the fuel feed pipe whilesupporting the fuel filter with another wrench, asshown.5. Remove the fuel filter clamp and fuel filter.6. When assembling, use new washers as shown.NOTE: Clean the flared joint of high pressure hosesthoroughly before reconnecting them.
38 US gallons equals 143.8 liters, rounded to the nearest tenth of a liter.