in the dist.
inside the fuse/relay center probably under the hood
The hood release is in the glove box.
under the left dashboard. Also under the hood right near the battery.
The fuel pump relay on a 96 Geo Tracker is located in the main fuse box. It is positioned along the right side of the engine compartment, inside a water tight enclosure.
to tow a 1992 Geo Tracker you must either disconnect the drive shaft or use a tow dolly and tow it backwards or you will damage the transmission
on the firewall on the driver side, just follow the wire that is on the center of the distriburter cap
on the hrottle body
in the glove box
On the top of the transmission.
speeds? you for got speeds 3 for 3 4 for 5 and 5 for 5 ok.
THE FUEL FILTER FOR A 91 GEO TRACKER IS LOCATED UNDER THE CAR NEXT TO THE FRAME BY THE REAR AXLE NEAR THE FUEL TANK.
You can get a fuse diagram for a 1992 Geo Metro in the car's owner's manual. You can also check with different auto stores.
what the hell is cas
Vanna White is begging for a NOUN... or even verbs?
The one with the wires running to the headlights :)
The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.
in the glove box
between the grill and the rad
The heater fuse for a 1993 Geo Tracker is located in the fuse box that is inside the engine compartment on top of the battery. It would also be a good idea to check the wires on the heater relay that is on the passenger side of the engine compartment on the fender wall. It is just behind the washer fluid receptacle.
Not without major modifications, and lots of money.
You can locate the fuse order for the 1993 Geo Tracker at locations such as 2 Car Pros and Rock Auto. The fuse order can also be obtained through the car manufacturer.
The PCM is located on the left side of the dash. Remove the speaker grill and then remove the speaker to gain access.
The speed sensor for a 1996 Geo Tracker is located on the transmission housing. The speed sensor is important , it keeps track of the tires and delivers the figures to the main system