0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is the Heater stuck on high temp on a 2001 mercury sable?
This sounds like a temperature blend door problem - with the door stuck in the heat position. See "Related Questions" below for information on Taurus/Sable blend door actuator motors and blend doors
How to repair the blend door in the heater on a 2005 Ford Explorer?
I do not have heat in the car and the blend door clicks. How do I access the blend door in a 2005 Ford Explorer?
Why is it on a 1997 ford f'150 only hot air no matter what the controls are set on and only air out of the defrost?
Check the blend door under the dash on the F150. Check the vacuum system as well. The vacuum controls the blend door and controls the heat as well as air from the defrost.
Is there a switch that controls the heat on a 2001 s10?
There is a temp blend door controlled by the temp control switch. The temp blend door is run by an actuator. If this actuator needs replacement it requires removal of the dash assembly (big job).
Could it be the blend door actuator that is not allowing your heater to go off?
Yes, it is possible the blend door is broken in the heat position.
Where is the bend door on a 2000 neon?
The blend door for a 2000 Neon is located behind the dash. The blend door controls the air flow for heat and ac.
How do ypu replace a blend door on a 1999 voyager?
To replace a blend door on a 1999 Voyager, you will begin by checking which side of the vehicle is not receiving heat. Then, remove the glove box door by squeezing the inside of the door toward the center of the door to access the blend door.
Does the blend door actuator direct where you want the heat to go?
With most heaters in vehicles the blend door mixes hot and cold air together to give you the temperature you want. Thus the name blend door
2001 S-10 has no heat?
Could be low on coolant or the thermostat is stuck open or the heater core is plugged or the temperature blend door actuator is broken.
You only have heat working on your 1998 mark?
Check your blend door.
Does the 1989 celiberty use an electrical heater core valve?
It does not. It is cable controlled thru a "blend door". If you are having no heat, it could be because of a clogged heater core, or the cable has came off the blend door, or the blend door control.
Will the heat work if you completely remove the blend door?
No it becomes an Erect Penis
