Just below the intake manifold.
How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L
under the distributor!
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
The intake air temperature sensor on a 2007 Honda Civic is found inside the intake system. The sensor is placed near the air filter box.
The intake air temperature sensor on a 1991 Honda Civic is found on the intake. The intake air temperature reads to climate of the air that is being sucked in through to the engine.
On the back of the block, below the intake manifold.
IT is a Intake Air Temperature sensor
It will be over by the air filter's box- mounted in with the MAF sensor, in the tube going from the filter box to the intake.
AnswerIts located on the intake manifold somewhere It is located on the driver's side of the intake parallel of the brake master cylinder.
preludepower.com take visit there you will be among friends
its for a performance chip
On the Prelude there are 2 O2 Sensors. They are on the exhaust manifold on the front of the engine. You will need to remove part of the plastic air intake in order to reach them.
the sensor is located on the air cleaner housing, right under the air filter.
It depends on which version of Prelude (there were five generations) you are referring to.
one is located at the thermostat housing. the other is in the bottom of the radiator.
The cylinder position sensor is located in the distributor.
The knock sensor is on the back of the block. If you're looking from under the car it's above the oil filter. It is between the oil filter and the intake manifold.
Only the 1996 and newer Honda's have a i.a.t sensor. It is located in the air intake tube that runs to the throttle body/intake manifold.
which are you referring to? The AIT (Air intake Temp) Sensor is located on the intake hose (the factory rubber air intake arm) it is a 2 wire sensor The Coolant Temp sensor is a One Wire on the side of the head under the distributor.
The O2 sensor on a Honda Prelude is found on the exhaust pipes of the vehicle. They are located near the catalytic converter which is place on the underside of the chassis.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
Behind the timing belt cover
It is attached to the black rubber intake hose the conects the airbox ( where the air filter is located) and the Throttle body (connected to the intake manifold).