The cam sensor is a flat plastic thing with a coil of wire in it that tells the computer what position the camshaft is in.
The shaft is a big rod with eccentrics on it also known as a bumpstick which pushes the engine valves open. It is the second largest rotating part in the engine. Do not break it.
Back of the block, about two inches above oil pan.
no the stratus version has different sensor plugs and tha exle shaft supports are different
how to chance a CV shaft on a 1997 dodge stratus
There is a sensor on the cam shaft that may be effecting things.
it could be the crank shaft sensor or cam sensor i would have the codes pulled to see if these come up.
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
The camshaft sensor is located on the drivers side top of engine at the end of the valve cover.
It is inside the distributor.
Yes, it is located on the right axle shaft housing on the trans.
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
It is in the side of the block, behind the starter.
On the trans, where the pass side axle shaft comes out.