The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
Above the oil filter, one 13 mm bolt.
It does not have a maf sensor.
the crank sensor is located on the top front of the tranny
where is the crankshaft sensor located on a 1993 dodge intrepid
There are two speed sensors on a 1996 Dodge Avenger, an input speed sensor and an output speed sensor. Both are located on the front of the transmission.
On the v6, yes.
No crank sensor, only the sensor in the distributor.
Inside the distributor
The camshaft sensor is located on the drivers side top of engine at the end of the valve cover.
this is for a 2.4 ,you have to get under the car and its located directly across from the rear engine mount on the crank you will have to remove 2 bolts from the heat shield(looks like thick aluminum foil) to get a good view but you will see the 2 wires running to the sensor tight fit but not bad.
I have a 1999 dodge avenger es and my crank sensor was under the battery housing. Remove the battery and the housing and look underneath if it is like mine it sits on top of the transmission housing. Its attached with one bolt. Easy fix. My sensor cost me 60 dollars. Good luck.....
Drivers Side Grounded to the block.