this is for a 2.4 ,you have to get under the car and its located directly across from the rear engine mount on the crank you will have to remove 2 bolts from the heat shield(looks like thick aluminum foil) to get a good view but you will see the 2 wires running to the sensor tight fit but not bad.
The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.
Above the oil filter, one 13 mm bolt.
the crank sensor is located on the top front of the tranny
where is the crankshaft sensor located on a 1993 dodge intrepid
No crank sensor, only the sensor in the distributor.
Inside the distributor
I have a 1999 dodge avenger es and my crank sensor was under the battery housing. Remove the battery and the housing and look underneath if it is like mine it sits on top of the transmission housing. Its attached with one bolt. Easy fix. My sensor cost me 60 dollars. Good luck.....
Drivers Side Grounded to the block.
the 1995 and before 3.0L's only have the sensor in the distributor. No crank sensor.
Check for trouble codes. Possible cam or crank sensor.
Check the link for locations of crankshaft sensor on 2.0, 2.4 and 2.5l engines. http://www.autozone.com/addVehicleId,2340402/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528008987d
The Crank sensor is located on the transmission housing near the top at the back of the engine.