Where is located the button to reset the alarm on a Chrysler Cirrus Lxi 1998?
The factory alarm is reset with the keyless remote or by unlocking the driver side door with the key. If you have an aftermarket alarm, the reset could be anywhere, but is usually under the dash on the driver side.
How do you reset the alarm system for a 1999 Chrysler Town and Country when alarm causing car not to start?
Select the alarm you wish to change 1 or 2. Hold down the ALARM 1/ALARM 2 button for 3-5 sec The Hour will begin to blink. Adjust the hour with the ADJUST/ CHANNEL button. Press the ALARM 1/ALARM 2 button again the minutes will blink - Adjust minutes using the ADJUST/ CHANNEL button Press ALARM 1/ALARM 2 button once more to make everything stop blinking.
How do you stop the alarm from coming on when you put the key in the ignition of a 1997 Chrysler cirrus?
Unlock the drivers door with the key, that disarms the alarm. If that doesn't work, the switch probably broke off the back of the door lock cylinder inside the door. Its an easy fix and cheap too if you get a replacement from the junkyard. The alarm resets whenever you use the power locks and close all the doors. Even if the windows are open. Good luck.