Inside the fuel tank with the electric fuel pump
location of oil level sending unit 6.6 disel
On a 2001 Mercury Sable : The automatic transaxle ( transmission ) fluid level dipstick is near the firewall , in the area of the brake fluid reservoir , in the engine compartment
On a 2000 Mercury Sable : The automatic transaxle ( transmission ) fluid level dipstick would be near the firewall just to the drivers side of the engine ( where the transaxle is bolted to the engine )
On a 1996 Mercury Sable : The automatic transaxle ( transmission ) fluid level dipstick is near the firewall and the brake fluid reservoir ( looking from the FRONT of the vehicle it is to the left of the reservoir )
The amount of Freon you will need to fill your 2001 Mercury Sable air conditioning system is dependent upon how low the Freon level is. A recharge kit will have a gauge to tell you when the system is full.
have you checked the oil level in the transmission ? I'm betting the answer is no
no pressure, fluid drains back in.
I believe the type used is engraved into the transmission ( transaxle ) fluid level dipstick
To fix the heat in the 2000 Sable, check the coolant level first. Make sure that the engine is not heating, if it is then the thermostat or water pump could be bad. These are the most common causes of heat being out.
If you mean the exclamation point and the " P " above the word " BRAKE " in the lower right side of the gauge cluster in a 1998 Mercury Sable that means either the parking brake / emergency brake is on , or the brake fluid level in the brake master cylinder in your engine compartment is LOW
i have found that with my 97 sable the low coolant light comes on when my oil is low. same as your car can run hot when your extremely low or out of oil
A 2000 Mercury Sable might have a vibration at low speeds after changing the transmission fluid because of a lack of fluid or leaking fluid. Check the transmission case for leakage and check the fluid level before driving again.