The manifold absolute pressure (MAP) sensor is an important component to your 1994 General Motors Blazer/Jimmy's EFI system. This pressure sensor is located provisioned into the intake manifold assembly.
The 1994 S10 uses a MAP sensor, not a MAF sensor. We need to know size engine you have in that S10.
A 1995 S10 with the 4.3 L TBI requires 41 to 47 psi fuel pressure.
The vehicle speed sensor on a 1995 s10 pickup 2wd is on the tailshaft of the transmission. The 4wd is mounted on the tailshaft of the front differential.
on the top of the intake
Passenger side, side of cylinder head next to sparkplug, single wire sensor, needs offset 13/16 wrench to remove it.
its in the air intake TUBE from the air filter intake air temperature IAT
The one the ecm reads is located right next to the thermostat housing.
If it is a Vortec it will be inside the tube running from the intake to the air filter it is a rubber hose with this stuck in it!
yes it will
Yes.
There is no adjustment to my knowledge.